Halloween wreaths are the perfect addition to your home decor! Learn how to make a Halloween wreath with cupcake wrappers, which is perfect for mantel or hanging in your home. You will find a step by step DIY tutorial below for your cupcake wrapper wreath. Have fun!
Cupcake Wrapper Wreath
This Halloween wreath is made from cupcake wrappers! Its so easy to do while you sit and watch tv and because cupcake wrappers are so readily available, you can customize a whole lot of them for very occasion.
Before you get started, you will need the following items.
- 150 Mini Orange Cupcake Liners
- 150 Mini Orange Black Cupcake Liners
- Round Foam Wreath Form
(mine is 11.5″ in diameter)
- Pins -something similar to #20 1-14″ pins. But almost anything will work.
- 1-1/2″ wide satin ribbon
for hanging
Please note before making your wreath: Products above will cover the inside, front and outside of wreath, but NOT the back. If you are hanging your wreath where both sides will be seen and it will not be flat against a door or window, please double the amount of wrappers you need.
How to make a Halloween Wreath
Below you find a step by step picture tutorial on how you make your wreath! At the bottom, there is a printable version of the tutorial instructions if you prefer to print out.
For each wrapper you pin onto your wreath form, you’ll actually be pinning on 2 wrappers at the same time.
Flatten one cupcake wrapper and reverse it (so it’s outside in) and place it inside of a “right side up” cupcake wrapper. Open the two wrappers a bit by flattening them
Use a push pin and push it through both wrappers.
Then press it onto the wreath form.
It’s easiest if you keep the pins to the “open side” of the wreath form as shown.
Repeat until the entire wreath form is covered.
Cut a piece of ribbon the desired length
Fold it in half and pin it to the back of the wreath form.
Hang as desired.
- 150 Mini Orange Cupcake Liners
- 150 Mini Orange Black Cupcake Liners
- Round Foam Wreath Form (mine is 11.5" in diameter)
- Pins -something similar to #20 1-14" pins. But almost anything will work.
- 1-1/2" wide satin ribbon for hanging
- For each wrapper you pin onto your wreath form, you'll actually be pinning on 2 wrappers at the same time.
- Flatten one cupcake wrapper and reverse it (so it's outside in) and place it inside of a "right side up" cupcake wrapper. Open the two wrappers a bit by flattening them.
- Fold the 2 wrappers together a bit in the center to create some dimension or a flower like shape. Use a push pin and push it through both wrappers.
- Then press it onto the wreath form.
- It's easiest if you keep the pins to the "open side" of the wreath form as shown.
- Repeat until the entire wreath form is covered. Cut a piece of ribbon the desired length.
- Fold it in half and pin it to the back of the wreath form.
Ready for more Halloween fun?
‘
